OptiBrush™ Bartex Mat

• YARN: Coarse Continuous filament Solution Dyed Nylon.
• YARN WEIGHT: 1,300 g/m²
• PILE THICKNESS: 10 mm
• TOTAL WEIGHT: 5,20 kg/m²
• PRIMARY BACKING: 100% recycled PET non-woven
• RUBBER BACKING: 100% nitrile rubber for maximum oil resistance, durability, and performance. Compression-molded with reinforced borders on all four sides. There is 34% post industrial recycled content in the polymer.  
• BORDER THICKNESS: 2.9 mm
• BORDER WIDTH: 1.5 cm
• SIZE VARIANCE: +/- 2% 

OptiBrush mats can be cleaned in several different ways:

1. They can be commercially laundered (see Laundering Instructions).
2. Vacuumed regularly (daily in high-traffic areas; weekly in lower-traffic applications).
3. Cleaned with an extractor, or hosed off as necessary to remove heavy soil.

Hang to dry. Mats should always be dry before they are placed back in service.

1. Flush, 2-3 Min. on a medium water level with a maximum temperature of 49°C
2. Flush (optional), 2-3 Min. on a medium water level with a maximum temperature of 49 °C
3. Break, 2-3 Min. on a high water level with a maximum temperature of 49 °C
4. Rinse, 2 Min. on a high water level with cold temperature
5. Rinse, 2 Min. on a high water level with cold temperature
6. Extract on low speed, 1-2 Min.
7. Shake out with the drum turning, 1 Min.
8. Extract, on a maximum of 250G, 3-5 Min.
9. Dry (optional), 5-10 Min. with a maximum basket temperature of 82 °C
10. Cool down, 5 Min.

Additional Recommendations:

• It’s recommended that Optibrush mats are washed separate from other mats.
• Optigraphic & Diplomats can be washed together with other SDN mats.
• For Heavy Soiled Mats, increase temperature up to max. 71°C.
• Break should not exceed pH of 9,5; use low pH non-ionic detergents.
• Do not overdry mats; Basket-temperature of dryer should not exceed 82°C.
• If mats are not dried, final rinse can be increased to 49°C. This will reduce moisture retention following extraction.
• Lay Mats flat following removal from washer; allow mats to cool before rolling.